The print shop demo how to#

Please see the section Fill Resin Tray with Material for more information.Īlways wear 100% nitrile gloves when handling the print Platform.ĬAUTION: Do not leave upper-build-chamber door open for an extended time. The new resin tray is now ready to be filled with resin.Ensure that a print platform is installed and, on the Printer, tap the icon on the touch screen. This will change the unit from 'confirm as ready' to 'ready to print,' as in the screens below.

Tap the Enable switch, and then tap Enable on the confirmation screen. Go to the Settings screen > Printer Info Card for the Printer you wish to re-enable.NOTE: The printer must be both 'enabled' on the Controller screen and 'marked as ready' on the printer screen in order to receive a print job. Close the lower-chamber door and enable the Printer, using the same method you used in Step 1, above:.If they do not engage, please see the Hardware Troubleshooting section. Look at both tension arms and ensure that they are engaged. Close the upper-chamber door and push the tension toggle button.Resin tray shown upside-down for reference Ensure that the tray is fully seated and level inside the chassis. It should fit snuggly in the holder on the chassis. Carefully lower the new resin tray into place, concave side up, as seen at the right.If the tray has resin inside, it is best to remove it with a drip tray underneath.

Wearing 100% nitrile gloves, open the upper-chamber door, remove the old resin tray, and determine if it needs to be cleaned or discarded, according to the section Clean Resin Trays.

Avoid the tension arm areas at all times. Personal Injury Warning: Failure to avoid the pneumatic tension arms may result in personal injury. To untension the resin tray, open the lower-chamber door and push the tension toggle button.

It is recommended to only add/remove tension with the upper-build-chamber door closed.

This will change the unit from 'ready to print' to 'confirm as ready,' as in the screens below.

On the Printer, tap the button on the touch screen.

Tap the Enable switch, and then tap Disable on the confirmation screen.

Go to the Status tab and expand the Printer Info Card on the Printer on which you wish to replace the bottle.

Disable the Printer so that it will not receive any new jobs until you re-enable it.

This section assumes that your 3D Systems installer has already installed your first resin tray and you are replacing it with another.

The print shop demo how to#

This section will demonstrate how to properly install the resin tray and tension it. If you have not read the Resin Tray Guidelines, please read them before handling the resin tray.Įach Printer comes with one resin tray.

The LED in the power button will turn white and the GUI will boot up to the screen at the right.

Press the power buttons on all Printers.

The Controller's touch screen will eventually bring up the Modular GUI (graphical user interface).ĬAUTION: Ensure that all machine doors are closed before starting it up. Give the system a few moments to boot up.The power button is located just above the power inlet.If you must change them, contact 3D Systems Service to ensure this is done properly. NOTE: Do not change the Modular network connections that your 3D Systems installer set up for you. However, if the system or any of its components have unexpectedly shut down, or if you have shut them down, this section describes how to start up the system's components. Your 3D Systems certified installer should have powered on your system for you.